01The challenge
The old jack had to be removed from the trailer tongue, and the replacement needed a mounting location with enough clearance to operate and pivot into its stowed position. The mounting plate, weld areas and nearby light wiring all needed attention.
02The repair
- Safely supported the trailer with jack stands.
- Ground and cut the welds to remove the old jack.
- Test-fitted the new jack to check clearance and prevent interference.
- Removed the backing plate from the new jack and temporarily positioned it on the frame.
- Marked the plate location on the frame and ground off the paint in the weld areas.
- Tack-welded the plate in position, then welded it to the trailer frame.
- Painted all exposed metal, leaving the pivot cylinder unpainted.
- Relocated the trailer light wires.
- Installed the new jack and tested its operation.
03The result
The replacement jack is installed, the mounting plate is welded and painted, the light wires are relocated, and the jack has been tested. Another Happy Customer...